Z-Com XG-580 PLUS User Manual download pdf (Page 7)

Besides, this is also used when you forget the password.

Hardware Installation

Take the following steps to set up your Access Point.

 Site Selection

Before installation, determine the Access Point location. Proper placement of the Access Point is

critical to ensure optimum radio range and performance. You may use the Site Survey and

Access Points Browser utility (The utilities included with the wireless PC Card) to choose a

proper placement for your Access Point. Typically, the best location to place your Access Point

at your site is the center of your wireless coverage area. Try to place your mobile stations within

the line of sight. Obstructions may impede performance of the Access Point.

 Access Point Placement

You can place the Access Point on a flat surface such as a table or cabinet, or mount the unit on a

vertical surface like a wall. The integrated antenna of your Access Point performs best in an open

environment with as few obstructions as possible. In most situations placing the Access Point as

pictured below will provide satisfactory performance results.

 Connect the Ethernet Cable

The 54Mbps Wireless LAN Access Point supports 10/100M Ethernet connection.Attach your

UTP Ethernet cable to the RJ-45 connector on the Access Point. Then connect the other end of

the RJ-45 cable to a hub or a station.

 Power On

Connect the power adapter to the power socket. Your Access Point then will automatically enter

the self-test phase. During the self-test, the LAN will flash. Finally,the PWR LED will light

permanently as the Access Point enters normal operation.

Initialize

Have initial value , network of bridge whether which is short of province parameter set up ,

is it install after finishing is it can make working to it to supply powering in hardware to need

only.

Warning：We cannot assume the responsibility for the damage from using with the

other power adapter supplier.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

No comments

Z-Com XG-580 PLUS User Manual Page 7